Please note, that the Phoenix Contact EEM371/370 come with a static preset IP address. To connect the power meter to your local network, you must configure it with the correct IP settings suitable for your LAN.
Ensure that the Powermeter is correctly installed according to these instructions.
The default IP settings are:
- IP address: 192.168.1.2
- Subnetmask: 255.255.255.0
- Standard Gateway: 0.0.0.0
- DHCP: Disabled
- Password (Webserver): adm1n
Change the above access data for your security
¶ 1. Connect the EEM370/371 to the 230V AC power supply.
¶ 2. Connect the power meter to your Windows PC using an ethernet cable.
¶ 3. In Windows, go to Settings -> Network & Internet -> Ethernet.
¶ 4. You should see a network labeled "Unidentified Network", click this network.
¶ 5. On the following page, click on "Edit" under "IP Settings"
¶ 6. Select the "manual" option from the dropdown.
¶ 7. Click on the button to enable IPv4
¶ 8. Use the following settings and click save.
The setup in Windows is done. You can now continue with
Adjusting powermeter settings.
¶ Adjusting powermeter settings
Open your favorite browser, and navigate to http://192.168.1.2 or the IP address of the powermeter. The configuration page of the powermeter will load. Navigate to the Network settings -> settings. Click the dropdown and adjust the mode to "Dynamic (DHCP)".
Configure the remaining settings according to your infrastructure. Once you finish the configuration and click Complete, you should see the following page.
The powermeter is now configured for DHCP, and will receive an IP when connected to a router.